Tim Holtz® Adirondack® Alcohol Ink Earthtones - Butterscotch

Metal

1. Start with clean metal, to remove all traces of skin oils and anything else that may resist or affect the ink. Wash both sides of your metal thoroughly with liquid dish soap.
2. After washing off all of the dish soap, sprinkle a small amount of baking soda onto both sides of your metal and scrub it well with a toothbrush, scrubbing in the same direction as the grain. If no grain, use a light circular motion. Dry thoroughly with a paper towel.
3. Do not let your skin touch the metal as this may add oil back to the piece.
4. Add one drop at a time. Liquid will spread quickly. Blend with Q-tip if necessary.
5. Let dry completely before handling.
6. Seal with a water based sealer.

Polymer Clay

1. Make a thin sheet of translucent polymer clay.
2. Squeeze drops of alcohol ink onto the translucent polymer clay. The alcohol ink will dry faster if spread over a larger area. Add a drop or two at a time.
3. Spread the alcohol ink over the surface of the sheet of clay with a palette knife.
4. Clean knife with rubbing alcohol immediately after use.
5. Let the ink dry completely before incorporating to mix the color.
6. Knead the clay ensuring the color is mixed all the way through. A Pasta machine can also be used.
7. If a more intense color is needed, roll out the clay and add more ink and follow the steps as noted above.